Trango Broadband M900S - Manual (Page 21)

Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual M900S Rev. C Page 17
SU Ranging Test
This test reports the SU’s
distance from the AP in miles,
received signal strength for
uplink and downlink, and SU Tx
Power. Use a link budget calculator to analyze results.
Advanced Setup Page
The Advanced Set up page includes several important parameters including RF TX Power, RF RX Threshold,
Target RSSI from SU (AP only), and Channel Table.
RF TX Power: Sets the conducted RF power output of the radio. Highest allowable setting is 26 dBm.
Lowest setting is –4 dBm. This value does not include antenna gain. A higher number is
more powerful.
RF RX Threshold: Sets the receive threshold of the radio. The radio will not process signals received below
this level, so it is very useful for interference mitigation. For a smaller radius of
operation use a higher threshold (-75 is higher than -80).
Target RSSI from SU: Used by the powerleveling process to automatically adjust the RF output power level of
all SUs in a sector so the signal strength from each SU as measured at the AP will be
roughly equal.
Channel Table: Assigns channel numbers to actual frequencies of operation. Default settings allow the
largest number of channels (4) within the band, while still maintaining 6 MHz channel
spacing.