Trango Broadband M900S - Manual (Page 50)

Trango Broadband Wireless — User Manual M900S Rev. C Page 46
Command Radio Description Access
targetrssi <dBm, -90..-50> AP Change target RSSI. Note: Target RSSI must be +5 dB more than
rfrxth (RFRX Threshold).
default = -60 rw
tftpd AP/SU display current TFTPD status (status is either on or off) This
command will also list any contents of the TFTP buffer. ro/rw
tftpd <on | off> AP/SU enable or disable TFTPD service. TFTPD must be on in order to
upload new firmware or new SUDB file. rw
updateflash <systemsetting | ss> AP/SU Save current settings. This command can be issued in several ways:
save ss, updateflash systemsetting, save systemsetting, and
updateflash ss rw
updateflash <mainimage | fpgaimage>
<current chscksum> <new checksum> AP/SU Retrieve uploaded firmware from TFTP buffer, verify checksum,
and write to flash memory at main or FPGA image section.
rw
updateflash sudb AP Save SUDB into flash memory rw
ver AP/SU Display firmware and date codes
1. Version number and date code
2. Firmware and FPGA version code
3. Firmware and FPGA image checksum
ro/rw