Transcend Information TS8GMP840 - Manual (Page 38)

SETTI
NG
S
SETTI
NG
S
2. Push the “Menu Switch” down (Next) or up (Previous) to switch between the 3
Record Quality
settings: Low – Middle – High. Press the “Menu Switch” inwards (MENU) to
select the Record Quality level and return to the SETTINGS Menu.
Sample rate Channels 2GB 4GB
Low (8KHz) 1 (stereo/mono) 64/128 hrs 128/256 hrs
Middle (16KHz) 1 (stereo/mono) 32/64 hrs 64/128 hrs
Record Sound
High (32KHz) 1 (stereo/mono) 16/32 hrs 32/64 hrs
If not enough memory space is available, or the battery power is too low, the MP840 cannot support
the maximum recording capacity as outlined in the above table.
The closer you move the MP840’s Microphone to the source of the sound the higher the quality of the
recording.
RADIO Recordings are recorded in Stereo. MIC Recordings are recorded in Mono.
VAD (Voice Activation Detection)
VAD allows the MP840 to make gapless audio recordings. This means the player will only begin recording
when it detects the subject is speaking, if the person(s) pauses, or stops speaking the MP840 will stop
recording until the person(s) starts speaking again. This allows you to make complete and very easy to
listen to recordings.
1. In the SETTINGS Menu, push the “Menu Switch” down (Next) or up (Previous) to
select the VAD item, then press the “Menu Switch” inwards (MENU) to enter the VAD Mode.