Tyco Electronics M7200 - Manual (Page 26)

MM-011553-001, Rev. A
26
If the radio is operating properly but side tones are not heard when the menu buttons are pressed, the side
tones are probably turned off. To turn them back on, access the “Side Tone” menu and select a setting
other than “off.”
Use the following procedure set side tone level:
1. Use to cycle through the menu until the “Side Menu” appears in the bottom line of the
display.
2. Use to change to the desired level (Off, Low, Medium, and High). To turn side tones
completely off, use the “Off” setting.
6.20 CHANGE OPERATING MODE
When operating the M7200 mobile radio in P25, EDACS, or Conventional mode, refer to
the standard M7200 operator’s manual, MM23016, available online at
www.macom-wireless.com.
1. Use to cycle through the menu until the “Mode Menu” appears in the bottom line of the
display.
2. Use to choose an available mode. Press MENU and confirm (Y/N) with and press
MENU again.
6.21 RECEIVING AND TRANSMITTING VOICE CALLS
As soon as the radio completes the startup/log-on/provision/self-test sequence and registers on the
OpenSky network, voice calls from talk groups in the active profile will be audible.
6.21.1 Receiving a Voice Call
No action is required to receive a voice call. The display responds to incoming voice calls as follows:
• When the dwell display is set to received talk group and the scan mode is Normal or Fixed:
a. If the received talk group matches the selected talk group, then the alias (if available) or user id of
the incoming caller is displayed.
b. If the received talk group does not match the selected talk group, then the received talk group
name is displayed
• When the dwell display is set to received talk group and the scan mode is None:
a. If the received talk group matches the selected talk group, then the alias (if available) or the user
id of the incoming caller is displayed.
b. If the received talk group does not match the selected talk group, then None is displayed.
• When the dwell display is not set to received talk group, then there is no display indication of an
incoming call.
Refer to Section 6.25 for detailed information on talk group scanning. Refer to Section 6.30 for detailed
information regarding sending and receiving encrypted calls.