Sony SLV-SE20UX - Manual (Page 30)

Getting Started 30
2
Enter your personal code.
1 Press >/. to select a character.
Each time you press >, the character
changes as shown below.
A n B n … n Z n 0 n 1 n … n 9
n (blank space) n – (hyphen) n A
2 Press / to set the next character.
The next space is highlighted.
To correct a character, press ?// until the character you want
to correct is highlighted, then reset it.
You can set up to 11 characters for your personal code.
3
Press OK.
A confirmation screen appears.
4
If the displayed personal code is correct, press OK.
If the displayed personal code is wrong, press CLEAR and continue
from step 2.
To confirm your personal code
While the VCR is turned off and there is no tape in the VCR, hold down
P
PAUSE and I /u ON/STANDBY on the VCR simultaneously for more
than three seconds. The entered personal code appears on the TV screen.
Press any button to enter normal viewing mode.
Note
• The menu disappears automatically if you don’t proceed for more than a few
minutes.
CLEAR
MENU EXIT :
SECURITY FUNCTION
–
PERSONAL CODE
WB–1 5 7 8 –
CONFIRM :
SET :
OK
SELECT :
– –
MENU EXIT :
SECURITY FUNCTION
–
PERSONAL CODE
WB–1 5 7 8 – – –
CANCEL : CLEAR
FINAL CONFIRM OK :
Setting your personal code (continued)
OK
PLAY
OK
PLAY
OK
PLAY