MAXWELL MW-3552 Y - Manual (Page 8)

FOR HOUSEHOLD USAGE ONLY
BEFORE USING THE UNIT FOR THE FIRST TIME
• Unpack the unit and remove the packing materials. Examine the unit for damages. Do not switch
on the unit if there are any damages in it.
Note:
− if the unit was subjected to negative temperatures, before switching it on for the first time, keep
it at room temperature for 30 minutes.
− use the unit at +5 - +40°С temperature, and relative humidity less than 80%.
− water temperature should not exceed +40°С.
• Before switching on the unit, make sure that the voltage of the electric network corresponds to the
operating voltage of the unit.
Using the ultrasonic air humidifier
1. Remove the nozzle (1) from the water tank (2).
2. Remove the water tank (2) from unit.
3. Turn over the tank (2); unscrew the lid (3), by turning it anti clockwise.
4. Fill the water tank (2) with necessary quantity of water and screw the lid (3), by turning it clock-
wise.
5. Set the filled tank (2) on the body of the unit.
6. Insert the plug into the socket.
7. Switch on the unit, by turning the switch (5) clockwise, the indicator (6) will light green.
8. Regulate steam intensity by turning the regulator (5).
9. If there is no water in the water tank (2) the indicator will light red
10. Use the switch (5) to switch off the unit and then unplug it. Fill the tank (2) with water and set
the filled tank on the body of the unit.
11. Upon termination of work turn the unit off by turning the regulator (5) counter-clockwise up to
full stop, the indicator of operation (6) will go out.
Clean and care
Warning: Always switch off and unplug the unit before cleaning.
Hard water causes appearance of scale on the “sprayer”(4) and in the operating chamber; it leads to
improper operation of the unit and appearance of white deposit on the interior objects. To avoid it:
− use boiled water or water, which stood for some time, water, purified by filter or distilled water;
− clean the operating chamber (4) weekly;
− change water in the water tank (2) more often.
Weekly care
− Once a week carefully wash the water tank (2) and the operating chamber (4) with a neutral
washing liquid solution. After it rinse them thoroughly with water.
− Add 5-10 drops of the cleaning agent on the “sprayer” (4); wait about 2-5 minutes. Use the
brush (7) to remove the deposit from the surface of the “sprayer” (4).
Note:
• As a cleaning agent for the “sprayer” you can use substances for scale removal in kettles.
• Do not immerse the unit into water or other liquids.
8 8
ENGLISH
3552.indd 8 3552.indd 8 09.09.2011 15:00:44 09.09.2011 15:00:44