E. filling fuel tank, Stop engine and allow it to cool before refueling, F. electrical power – Tecumseh OH195SA/OH195SP (OHSK50-75) User Manual

Page 10: Figure 15. possible fuel fill cap(s), Figure 16. fuel valve positions, Power cord to outlet, Switch box, Starter button, Schuko plug, Power cord to switch box on engine

Advertising
background image

Page 8

4-Cycle • Snow King Engine

181-1275-14

E. Filling Fuel Tank

An adult should fuel this engine.
NEVER allow children to refuel this

engine. Gasoline (fuel) vapors are highly flammable and
can explode. Fuel vapors can spread and be ignited by a
spark or flame many feet away from engine. To prevent
injury or death from fuel fires, follow these instructions:

1.

Stop engine and allow it to cool before refueling.

2.

Be sure engine is outdoors and in a well-ventilated
area.

3.

Clean area around fuel fill cap and remove fuel fill cap.
See Figure 14 on page 7. Afterward, continue reading
instructions below.

NOTE

For recommended fuel, see Table 3 and "III. Oil and Fuel
Specifications" instructions on page 4. Afterward, continue
reading instructions below.

4.

Using an approved red GASOLINE container, add fuel
slowly, being careful to avoid spilling. DO NOT overfill
fuel tank. Leave space in the tank to allow fuel to
expand without overflowing.

5.

Replace fuel fill cap securely and wipe up spilled fuel
before starting engine. If fuel is spilled DO NOT start
engine. Move machine away from area of spillage.
Avoid creating any source of ignition until fuel vapors
are gone.

NOTE

Replace a damaged or missing fuel fill cap only with a
genuine TecumsehPower replacement Fuel Fill Cap.
Failure to do so may VOID YOUR WARRANTY.
See Figure 15.

6.

Be sure fuel valve, if present (see equipment
manufacturer’s instructions) is open. See Figure 16.

F.

Electrical Power

NOTES

When connecting power cord, always connect power cord
to switch box on engine first; then into outlet. See Figure 17.

For European 220V AC applications use an appropriate
grounded extension lead available locally.

Determine what type of power source outlet you will be
connecting the power cord to, before you start your engine.
See "A. Engines with Electric Starters" instructions on
page 10.

WARNING

Figure 15. Possible Fuel Fill Cap(s)

Figure 16. Fuel Valve Positions

Figure 17. Electric Starter Connections

Front View

Bottom View

Fuel Tank

Fuel Valve “OPEN”
Position Shown

Turn Valve
Clockwise To
“OFF” Position

1. Power Cord to Outlet

2. Switch Box

3. Starter Button

4. Schuko Plug

5. Power Cord to Switch Box on Engine

6. Electric Starter Switch Box on Engine

1

5

2

3

120V AC

1

5

2

3

4

220V AC

6

Advertising
This manual is related to the following products: