Iii. oil and fuel specifications, A. oil, B. fuel – Tecumseh OH195SA/OH195SP (OHSK50-75) User Manual

Page 6: Iv. before starting your engine, A. checking oil level, Table 1. recommended oil, Table 2. oil sump capacity, Ounces, U.s. pints, Liters

Advertising
background image

Page 4

4-Cycle • Snow King Engine

181-1275-14

III. Oil and Fuel Specifications

A. Oil

To operate your engine you need to use a clean, high
quality, detergent oil. For recommended engine oil, see
Table 1. In addition, you need to be sure the oil sump
contains the correct amount of oil to operate properly. For
recommended oil sump capacity, see Table 2.

NOTES

Be sure original container is marked A.P.I. Service “SL/SJ”.

Using multigrade oil above 32°F (0°C) will increase oil
consumption. SAE 10W40 is NOT recommended.

Special-formulated oils are available at your Authorized
TecumsehPower Servicing Dealer.

B. Fuel

Use unleaded regular, unleaded premium or reformulated
automotive fuel only. You may use gasoline containing the
components identified in Table 3.

• DO NOT use leaded fuel.

• Fuel must be fresh and clean. NEVER use fuel left

over from last season or stored for long periods.

• NEVER mix oil with fuel.

• DO NOT use fuel containing Methanol

(Wood Alcohol).

The use of alternative fuels such as E85
or E20 are NOT recommended for use in

TecumsehPower engines. Alternative fuels with high
alcohol content can cause hard starting, poor engine
performance, and may cause internal engine damage.

NOTE

Damage and/or performance problems that occur from use
of fuels other than those listed in the Operator’s Manuals will
not be considered warranty.

IV. Before Starting Your Engine

A. Checking Oil Level

To avoid engine damage, it is important to:

• Check oil level before each use and every 5

operating hours when engine is warm. Check oil
level more frequently during engine break-in.

• Keep oil level between “FULL” and “ADD” marks on

oil fill cap/dipstick or to point of overflow on engines
with an oil fill cap/plug. See Figure 7.

• Be sure oil fill cap/dipstick or oil fill cap/plug is

tightened securely.

NOTES

DO NOT overfill oil filler. Doing so may result in oil carry-
over to the equipment and cause malfunction or damage.

DO NOT allow oil level to fall below the “ADD” mark on oil
fill cap/dipstick. Doing so may result in equipment
malfunction or damage.

Contact your Authorized TecumsehPower Servicing Dealer
for TecumsehPower Oil.

Some engines are equipped with an oil fill cap/dipstick or oil
fill cap/plug (see equipment manufacturer’s instructions).
To change the oil on your engine, see "B. Changing Oil"
instructions on page 17.

CAUTION

Table 1. Recommended Oil

Table 2. Oil Sump Capacity

Oil Sump Capacity

Engine

Ounces

U.S. Pints

Liters

Model Number

21

1-1/4

.62

LH195SA/LH195SP
OH195SA/OH195SP

26

1-5/8

.77

LH318SA/LH358SA
OH318SA

28

1-3/4

.83

OH358SA

Table 3. Recommended Fuel

Fuel Component

Percentage

Ethanol

10%

Grain Alcohol (“Gasohol”)

10%

MTBE (Methyl Tertiary Butyl Ether)

15%

ETBE (Ethyl Tertiary Butyl Ether)

15%

Figure 7. Engine Oil Level

-20 F

O

32 F

O

32 F

O

32 F

O

40 F

O

-20 C

O

20 F

O

40 C

O

30 C

O

20 C

O

10 C

O

0 C

O

-10 C

O

-30 C

O

0 F

O

60 F

O

80 F

O

100 F

O

Straight Grade

730225A or SAE 30W

TecumsehPower Part No.

Multi Grade

730226A or SAE 5W30 or SAE 10W

TecumsehPower Part No.

TecumsehPower

730263 or SAE 0W30

Synthetic Part No.

TecumsehPower Recommended Oil Usage

FULL

ADD

OK

Fill Between
“FULL” and “ADD”
Marks

Advertising
This manual is related to the following products: