Installation, Detaching a dome cover, Installing a camera – TOA Electronics C-CV854D-3 CE User Manual
Page 7
7
LOCK
LO
CK
L-type wrench
Dome cover
Case
5. INSTALLATION
Notes
· Do not remove the protective sheet attached to the dome cover until installation work is completed. Damage
to the dome cover could result if the protective sheet is removed during installation.
· A safety wire for connecting between the unit and ceiling is not supplied. Hook a safety wire for the unit itself
to the safety wire-fixing hole (M4, useful thread depth = 6 mm (0.24 inch)) as needed.
· Wrap self-adhesive insulation tape around coaxial cable connections and the power supply lead.
5.1. Detaching a Dome Cover
1. Detach the dome cover from the case.
Remove three screws fixing the dome cover with a supplied L-type wrench.
Note: The dome cover is connected to the case by a safety wire.
2. Detach the inner cover while pushing two of the sections indicated by arrows.
Push
Push
Detach upward.
5.2. Installing a Camera
5.2.1. Unexposed wiring
1. Make a cable entry hole as shown below in the ceiling or wall.
41
( 1.6
)
83.5
( 3.3
)
46 (1.8)
Camera unit
mounting hole
Camera center
Cable entry hole ø20 (
0.8)
Unit : mm (inch)
Note
When mounting the camera to a wall, make sure the
cable entry hole is positioned below the camera center.