Toshiba Blu-Ray Disc Player BDX1200KU - Manual (Page 14)

1
E
ng
lis
h
6 Customizing
This section describes the various setting
option of this Blu-ray Disc™ player.
If the setup option is grayed out, it means
the setting cannot be changed at the
current state.
General Setting
1. Press SETUP button on the remote
control. The Setup Menu appears.
System Screen Saver On
On
On
More...
More...
Language Disc Auto Playback
Playback CEC
Security Load Default
Network Upgrade
General Setting
SETUP Exit
Move cursor key to select menu option
then use “OK” key to select
2. Press  to select an option, then press
 to access.
3. Press / to select a setup option and
press .
4 . Select the setting you wish to change
and press OK to confirm.
- Press  to return to the previous menu.
[System]
To change the following system option to
personalize your Blu-ray Disc™ player .
• [Screen Saver]
Turn On or Off the screen saver mode.
It helps to protect the TV screen.
{ On } – Set the screen saver active
after approximately 5 minutes with no
operation. You can turn off the screen
saver by pressing the SETUP button.
- The Blu-ray Disc™ Player will switch to
standby mode if there is no operation
after the screen saver is engaged for
approximately 15 minutes.
{ Off } – Turn off the screen saver
mode.
• [Disc Auto Playback]
Turn On or Off the disc automatic
playback switching mode.
{On} – The disc playback automatically
after loading.
{Off} – Turn off disc auto playback
mode.
• [CEC]
This player supports REGZA-LINK which
uses the HDMI®-CEC (Consumer
Electronics Control) protocol. You can
use one single remote control to control
all REGZA-LINK-compliant devices that
are connected through HDMI
connectors.
{On} - Turns on REGZA-LINK features.
- With CEC on, during TV standby with
the Blu-ray Disc™ Player on, pressing
SETUP, PLAY/PAUSE will power on the
TV. When you turn the TV off, this unit
will automatically turn off.
{Off} - Disables REGZA-LINK features.
• [Load Default]
Reset all settings of Blu-ray Disc™ Player
to initial default state.
- Follow the instruction on the TV screen
to confirm the default setting operation.
1. Select Load Default.
2. A dialog box pops up shown as
below. Select OK.
Load Default
Do you want to load default?
OK Cancel
3.It may take awhile when loading
default is in progress. Please wait...
Load Default
30%
Loading default, please wait...
4. TV will display as follow:
OK Next
Welcome
to the Toshiba Blu-ray Disc Player Setting
Wizard.
Some simple settings are suggested before you
begin. You can also access detailed settings
from the Setup Menu.
5. Press OK, enter language setting. . Press OK, enter language setting.
Press/ to select a language option.
Previous
English
OK Next
Choose
an OSD language before starting.
The language selected will be applied not only
here but also in other OSD windows, menus
etc.
Français
Español