Tyco GoodKnight 420G - Manual (Page 13)

Revision A
GoodKnight 420G - Patient manual 7
INSTALLATION
This chapter shows you how to connect the various accessories and cables to your device. Before
beginning the installation, please check your device and its accessories, by referring to the chapter on
“Checking the components”. (See page 3).
CAUTION
In general, place the device on a stable surface. Avoid placing it too near a wall or any other
obstacle which could hamper the intake of air into the device.
Standard installation
1. Connect the patient tubing to the device. To do this, connect the hose onto the outlet connector
of the device. (See reference 5 in Figure 3, page 5).
Figure 5 – Connection of the patient tubing to the device
2. Prepare the mask as described in its instructions for use.
3. Connect the mask to the patient tubing free end.
4. Connect the cable of the power supply module to the supply connector located on the back of the
device. (See reference 6 in Figure 4, page 5).
CAUTION
Use only the specific power supply module provided with the device.
5. Connect the plug of the power supply module to the mains. The type of the device is displayed
for a few seconds then the following standby screen indicating the hours and the minutes :
7:14 Ÿ
The two points are blinking.
6. The device is ready to operate. Please refer now to the chapter “Use”. (See page 11).