Tyco GoodKnight 420G - Manual (Page 20)

Revision A
14 GoodKnight 420G - Manuel patient
Accessing information on the device
The display enables you to view the different information on the settings of the GoodKnight 420G.
(Refer to reference 1 in Figure 2, page 5).
The setting information is accessible whether the device is on standby or in operation. For this, just
press the Information Access button for one second. (See reference 2 in Figure 2, page 5). With each
additional key press, you access further data.
NOTE
In the following screens, the device is shown in operation mode and all the values are given as a guide
only.
10.0
cmH
2
O
P
Press for one
second on
Information
Access button
• The pressure level set by the doctor (equivalent to the
prescribed pressure when the device is running).
5
min
Press
Information
Access button
• The ramp time set by the doctor (period of time over which
the pressure gradually increases from the starting ramp
pressure to the pressure level).
4.0
cmH
2
O
P
Press
Information
Access button
• The starting ramp pressure (pressure level at the
beginning of ramp); this parameter is adjustable and visible
only if the ramp time is other than 0.
The symbol used shows that the parameter is adjustable.
You can increase or reduce the value displayed by using the
ON/OFF or Ramp keys. For further details, refer to the
chapter “Using the ramp”. (See page 12).
114
h
Press
Information
Access button
• The hour meter value (device operating time).
42 h
Press
Information
Access button
• The compliance meter value (time during which the
patient has breathed with the device).
Id *.*
Press
Information
Access button
• The GoodKnight 420G on-board software version.
Press the Information Access button again to exit the parameter setting menu.