Technicolor - Thomson mkiiLDK 23hs - Manual (Page 40)

4-8 Operator's Manual LDK 23HS mkII - HS Camera System Location of Controls and Functions
SAVE MENU BATT REC TAPE ND RE
- + ++ AW2 AW1 3,2 5,6
SAVE MENU BATT REC TAPE ND RE
- + ++ AW2 AW1 3,2 5,6
SAVE MENU BATT REC TAPE ND RE
- + ++ AW2 AW1 3,2 5,6
SAVE MENU BATT REC TAPE ND RE
- + ++ AW2 AW1 3,2 5,6
SAVE MENU BATT REC TAPE ND RE
- + ++ AW2 AW1 3,2 5,6
SAVE MENU BATT REC TAPE ND RE
- + ++ AW2 AW1 3,2 5,6
f00 f00 F3.7 F3.7 31 31
1
2
3
4
5
6
7
8
9
Viewfinder Indicators
1 Top indicators
BATT Function disabled.
REC This red indicator lights to indicate that the
camera is on-air.
It flashes when any
irregularity in the recording system occurs
(function depends on the type of recorder).
TAPE Yellow, when in triax (remote) mode: ISO-
indication.
RE This green indicator lights when the range
extender is selected or toggles when a call
switch is used.
2 Safe area marker
Indicates the safe area which represents 80% of the
whole viewfinder picture area. This is the minimal
area which will be seen on a TV-set.
3 Centre marker
This cross marks the centre of the picture.
4 Cadre marker
These dotted white lines represent the limits of the
16:9 picture in the 4:3 mode and the limits of the 4:3
picture in the 16:9 mode. The area outside the cadre
will be cut off when the picture is displayed on a
monitor with an other format. The dotted lines can be
switched to a low contrast area, see Installation
Manual.
5 Bottom indicators
The following green indicators light when:
-
gain is -
+ gain is +
++ gain is ++
AW2 colour temperature stored in memory position
2 is selected
AW1 colour temperature stored in memory position
1 is selected
3,2 colour temperature of 3200 K is selected
5,6 colour temperature of 5600 K is selected
6 Zoom indication
Indicates the degree to which the lens has been
zoomed in or out. This indicator only works when the
zoom signal is available from the lens.
7 Focus indication
Indicates where the lens has been focused. This
indicator only works when the focus signal is available
from the lens.
8 Zebra pattern
This diagonal line pattern warns the operator that the
area affected has risen above a predetermined level
of the full scale video exposure value. Level and range
are selectable via the menu control system.
9 Iris indication
Indicates the diafragm position. This indicator only
works when the iris signal is available from the lens.
aspect ratio 16:9 aspect ratio 4:3