TANDBERG D13841.01 - Manual (Page 13)

5 Configure the Gateway
13
2.1 Unpacking
To avoid damage to the unit during transportation, the 3G Gateway is delivered in a special
shipping box, which should contain the following components:

User Manual and other documentation on CD.

Rack-ears, screws and screwdriver.

Cables:
o Power cable
o One ISDN PRI cables or 4 ISDN BRI cables depending on the version
o Ethernet cable
o RS232 cable

TANDBERG 3G Gateway
Installation site preparations

Make sure that the 3G Gateway is accessible and that all cables can be easily
connected.

For ventilation: Leave a space of at least 10cm (4 inches) behind the 3G Gateway
’
s rear
panel and 10cm (4 inches) in front of the front panel.

The room in which you install the 3G Gateway should have an ambient temperature
between 0
º
C and 35
º
C (32
º
F and 95
º
F) and between 10% and 90% non-condensing
relative humidity.

Do not place heavy objects directly on top of the 3G Gateway.

Do not place hot objects directly on top, or directly beneath the 3G Gateway.

Use a grounded AC power outlet for the 3G Gateway.

You will need a CSU (Channel Service Unit) between your system and the PRI line from
your network provider.

Make sure that it is possible to receive and to make Mobile(h324M) video calls from
behind this line. Check this with your network operator!

If you are behind a PABX make sure that the PBABX is capable of routing Mobile
(H324M) video calls.