Tiger Products Co., Ltd COUGAR BOOM 7X30 - Manual (Page 127)

JD 7X30 COUGAR Parts Section 5-25
SAFETY LIGHT ASSEMBLY
SAFETY LIGHT INSTALLATION
1. Remove ground wire (-) from the battery
2. Remove right rear tire
3. Remove the bottom cover from the tail light. Locate the wire connecor on the tractor that has a
brown & green wire
4. Remove panel from right rear of outside of cab under the window
5. Install light bar to mounting bracket
(Note: Wiring should be routed through the bracket & come out the hole on the top of
the tube)
6. Install the light bar and bracket assembly in wheel well securing the three 1-1/4” bolts to the
fender
7. Use the bracket as a guide to drill 2, 5/16” holes in the wheel well and install 2 remaining 1”
capscrews and nylock nuts
8. Install the female 2-wire connector to the wires coming from the light making sure that the green
wires are common
9. Reconnect the battery ground wire (-) and test for proper operation
(Note: The marker light should flash with hazard lights and the right turn signal. The
light should burn steady with hazards and the left turn signal on.)
10. Reinstall all covers that were previously removed
11. Reinstall right side tire
ITEM PART NO. QTY. DESCRIPTION
1 34894 1 BRACKET, MOUNTING, JD72-7510,LIGHTING
2 21531 3 CAPSCREW, 1/4 x 1-1/4, NC
3 21530 2 CAPSCREW, 1/4 x 1, NC
4 21527 5 NYLOCK NUT, 1/4, NC
5 34859 1 MARKER LIGHT ASSEMBLY
* 6T1824 2 ZIP-TIE, 8” (NOT SHOWN)