Maintenance – Tiger Products Co., Ltd COUGAR BOOM 7X30 User Manual

Page 84

Advertising
background image

JD 7X30 COUGAR Maintenance Section 4-6

MAINTENANCE

SYMPTOMS

CAUSE

REMEDY

Mower will not start

1. Blown fuse

1. Check fuse between mower switch

or run

and ignition / replace

2. Ball valves closed 2. Make sure valves are open
3. Low oil level

3. Check Hyd. tank and fill

4. Line leak

4. Check all fittings and lines,

re-tighten or replace

5. Electronic

5a.

Without the tractor running, turn

solenoid faulty

the mower switch to on. A low

audible click should be heard if the
solenoid is engaging the solenoid
spool. If click is not heard, leave
switch in on position and with a
screwdriver or other steel object,
touch the small nut on the end of the
solenoid. If the metallic object is not
attracted to the nut, check the fuse
and wiring for an open circuit. If the
object is attracted but no “click” is
heard, replace the solenoid.

5b. Remove the four bolts holding the

small block to the main block. Lift
and remove small block being
careful not to damage O-rings / filter.
Clean filter and re-install.

5c. Remove large nut on side of large

valve block. Remove spring, and use
needle nose vise grip to pull spool
from block. Check block and spool
for contaminates and scratches.
Clean parts or replace if scratched.

Motor runs but

1. Belts

1. Inspect belts and pulleys. Replace

will not cut.

belts and repair as needed.

2. Tensioner

2. Adjust tensioner nut until flat washer

washer is flush with top of guide.

Motor turns slowly

1. Contaminants

1. Remove large nut on side of large

or not at all.

restricting spool

valve block. Remove spring, and use

movement in

needle nose vise grip to pull spool

valve body.

from block. Check block and spool
for contaminates and scratches.
Clean parts or replace if scratched.

2. Suction lines

2. Check for kinkes or obstruction in

obstructed

suction hose.

3. Low oil level

3. Check Hyd. tank level and fill.

Pump will not work

1. Excessive wear

1. Disassemble and repair.

on internal parts

Motor will not work

1. Excessive wear

1. Disassemble and repair.

on internal parts

Advertising