Texas Instruments TMS320DM6446 DVEVM v2.0 - Manual (Page 19)

Setting Up the Hardware
EVM Hardware Setup 2-5
10) If you plan to use the UART port for a console window, connect the
RS-232 null modem cable to the EVM UART port and a COM port on
your host Linux workstation. See Section 2.2, Connecting to a
Console Window for more about using a console window.
11) Plug in the LCD display to a power supply.
12) Plug in the NTSC/PAL video camera to a power supply.
13) Connect the power cable to the EVM power jack on the board. To be
ESD safe, plug in the other end of the power cable only after you
have connected the power cord to the board.
14) Power on the LCD display.
15) Power on the EVM board.
16) The initial screen of the demo software should be displayed on the
LCD display. Use the IR remote to run the software as described in
Chapter 3.