6 kit operation, 1 tsc2007evm-pdk block diagram, Jumpers – Texas Instruments TSC2007EVM User Manual
Page 5
www.ti.com
6
Kit Operation
6.1
TSC2007EVM-PDK Block Diagram
Kit Operation
Table 6. List of Jumpers
JUMPER
SHUNT POSITION
JUMPER DESCRIPTION
JMP1
2-3
Analog power select (default is +3.3VD)
JMP2
Closed
EEPROM address select. When installed and used with the USB-MODEVM, firmware for the
motherboard is executed from the EEPROM on the TSC2007EVM. This is the default mode.
The following section provides information on using the TSC2007EVM-PDK, including setup, program
installation, and program usage.
A block diagram of the TSC2007EVM-PDK is shown in
. The evaluation kit consists of two circuit
boards connected together. The motherboard is designated as the USB-MODEVM interface board; the
daughtercard is the TSC2007EVM described previously in this manual.
SLAU199 – March 2007
TSC2007EVM and TSC2007EVM-PDK User's Guide
5