TANDBERG Codian HD MCU 4500 Series - Manual (Page 8)

4
Connecting the MCU
Before you start
Step one: Connect power
Connect the power connector on the rear of the unit to the power supply using the
supplied power cable. (There is no On/Off switch.)
Step two: Connect to Ethernet Port A
Connect an Ethernet cable from Ethernet Port A to an Ethernet switch (rather than a
hub, to minimize interference from other devices on the network). The Ethernet
port is a 10/100/1000 Mbps auto-sensing connection
IMPORTANT
: Before installing the MCU, you must read the safety
information at http://www.codian.com/safety.htm
Only connect to Ethernet Port B if you need to connect the MCU to a
second subnet.
Do not connect Ethernet Port A and Ethernet Port B to the same subnet.
i
!