Top Innovations SF-475 - Manual (Page 8)

8 Top Innovations, Inc.
A
SSEMBLING THE
F
ABRIC
S
TEAMER
CONNECTING HOSE
1. Slide Hose fitting onto threaded Hose Base (FIGURE 5)
2. Turn Hose fitting clockwise to secure it to Hose Base (FIGURE 6).
NOTE: Hand-tighten Hose fitting only. Do not over-tighten.
3. Hang Steam Nozzle on specially designed Steam Nozzle Holder as shown
(FIGURE 7).
CAUTION: To prevent steam from causing bodily injury or damage to
surfaces, always hang Steam Nozzle on Steam Nozzle Holder when not in use.
Do not lay Hose on floor as condensation may build up inside, causing
unwanted water droplets in steam.
CAUTION: Pulling on Hose with excessive force may damage it, resulting in a
steam leak.
FIGURE 7 FIGURE 5 FIGURE 6
ATTACHING LINT REMOVER /
FABRIC BRUSH / CLOTH COVER
1. Make sure Lighted On/Off Switch is set to “Off”
position, and that unit is not emitting any steam.
Do not try to connect Lint Remover, Fabric
Brush or Cloth Cover while unit is emitting
steam, as this can cause burns and injury.
2. Align two pegs on back of accessory with
corresponding holes on face of Steam Nozzle.
Use care to properly align attachment as shown
(FIGURE 8), so as not to cover up steam holes
on nozzle face.
3. Press accessory firmly onto Steam Nozzle, until
it fits securely in place.
FIGURE 8