Top Innovations SF-475 - Manual (Page 9)

9 Top Innovations, Inc.
U
SING THE
F
ABRIC
S
TEAMER
FILLING WATER RESERVOIR WITH WATER
1. Place Fabric Steamer on a flat, level surface.
2. Make sure Lighted On/Off Switch is set to “Off” position and grounded power
cord is unplugged from electrical outlet.
3. Flip up Compartment Lid. Cautiously unscrew and remove Water Reservoir Cap.
4. Water Reservoir should always be emptied after each use. If it was not emptied
after the last use, empty it now. This will prevent over-filling.
5. Fill Measuring Cup to maximum fill line (16 oz. / 473 ml.) with water.
NOTE: To prolong the life of your Fabric Steamer, we recommend using
distilled or de-mineralized water.
6. Using Water Funnel, carefully pour water from Measuring Cup into Water
Reservoir through fill hole.
WARNING: Extreme caution should be used when pouring water into the
Water Reservoir. Do not look directly down into fill hole when filling. Keep
your free hand and any children or pets at a safe distance.
7. Depending on how long you intend to steam, you may repeat steps 5 & 6 up to
two more times, to a maximum of 48 oz. (1420 ml.) of water. See chart below
for a comparison of the amount of water vs. approximate steam time.
8. Replace Water Reservoir cap, ensuring that it is screwed on tightly to prevent hot
steam from escaping and causing injury.
9. Lower Compartment Lid back down.
IMPORTANT: When steamer is first activated, it is natural for it to spray
small amounts of water. This is due to condensation forming in the Hose, and
will dissipate within 30 seconds of use. To help clear condensation out of Hose
more quickly, try the following:
• Point Steam Nozzle towards ground, sink or tub and shake it to force water
out of Hose.
• Extend Hose vertically as far as possible to allow water to drain back into
Water Reservoir.