Tiger V1 - Manual (Page 2)

Tiger Lily Products TLP, Blinder, Bel, Escort, Valentine
PO Box 549 Tel
 303-678-9101
Cel: 720-635-3931
Niwot, CO, USA 80544 Fax 303-678-9103 Cel: 720-298-0557
Email [email protected]
Web
www.1stRadarDetectors.com
Rated #1, 360 Degree, High Performance, PRS1-STi-360™ Prowler Remote™ System
PROWLER Remote, PRS1-STi-360, PRS1-V-360, PRS2-V, PRS2 -STi, PRS3-V, PRS3- STi, PRS4-V, PRS4-STi, Got Performance are trademarks of Tiger Lily Products. All rights reserved. Copyright 1999 -2008.
Got Performance ™
Best in Test
Radar, Laser & Photo
Countermeasures
How To Change V1 Remote and Valentine One Programming. Call us at 303-678-9101 if you
want help in changing your V1 modes of operation. Change Modes at your own risk!
I. How to enter the Programming Mode.

Starting with the Control Knob in the "off" position, Press and hold-in Knob and at the same time turn the Knob “on;”
continue holding in the Knob until all front-panel lights are on (takes about 5 seconds).

Release the Control Knob.
II. How to determine your software version.

Press and immediately release the Control Knob (shown at right) to display software version. The
software-version number is four digits that display one digit at a time in the Bogey Counter-example:
2.869.

Note your software number, then see the tables on the following pages on features programmable in your unit.

Press and immediately release the Control Knob to exit software-version display and go to Step 1 programming.
III. How to program your desired features.

The feature character is indicated in the "Bogey Counter" (1, 2, 3, 4, 5, 6, 7, 8, A, b, C, d, E, F, G, H, J, or u).

To select the next Feature Character in the sequence, press and immediately release the Control Knob.

The Feature State is indicated by direction arrows on the Radar Locator. The Feature State is changed by pressing and
holding the Control Knob until the arrow switches to the opposite direction (takes about 3 seconds). NOTE: If you need
to return to an earlier Character in the sequence above, we recommend you switch off the power momentarily, then
restart at step I above. The numerical program modes of interest are as follows:

US/Canadian/HK Frequency: #1 (X band ON = OFF = ) Don’t change any other mode on US/Canada!

EUROPE / AU Frequency #1 (X band OFF = )

EUROPE / AU Frequency #2 (K = 24.125GHz : ON = )

EUROPE / AU Frequency #3 (Ka band ON = )

EUROPE / AU Band #4 (Laser ON = )

EUROPE / AU Frequency #4 #H (Ku ON )

EUROPE / AU Frequency #J (POP3 ON = )

EUROPE / AU Frequency #U (Euro Ka = 34.2GHz, Narrowband Ka ON = )
Do not change any other mode!