Topcom HBM 1000 User Manual
Page 15
Wireless IP Cam 2000 / Wired IP Cam 1000
15
Wireless IP Cam 2000 / Wired IP Cam 1000
ENGLISH
5.4
Network
•
IP Address Mode:
–
Enter the IP address / Subnet Mask and Default Gateway in case of fixed IP
address (recommended). The Gateway will be your Internet Router IP address.
–
If your network has a DHCP server, you can choose Dynamic IP. (not
recommended)
–
If the IP Cam is connected behind a DSL bridge, you can enter the PPPoE User
ID and Password to get connected to the Internet.
•
DNS IP Address: Two DNS server addresses can be entered. If your Internet router has
a DNS relay, you can enter your Router IP address here.
•
Dynamic DNS: In case the camera is connected directly to a cable/DSL modem, you
can enter the DynDNS setting if used.
•
Second HTTP Port: If you enable this option, you can use another port to view the IP
Cam. This option should be enabled when the DynDNS service is used in your router to
view the camera from a remote site.
•
UPNP: Enabled by default.
Please read the user guide “Use Dynamic DNS service” on the provided CD
for viewing the camera from a remote site by use of Dynamic DNS.