Topcom HBM 1000 - Manual (Page 3)

Wireless IP Cam 2000 / Wired IP Cam 1000 3
Wireless IP Cam 2000 / Wired IP Cam 1000
ENGLISH
1 Hardware installation
Attach the Camera Stand
The IP Camera comes with a camera stand. It has a swivel ball screw head that can be
attached to the camera's screw hole on the top/bottom panel. Attach the camera stand to the
camera and station it for your application.
Back panel
Ethernet connection: Connect an Ethernet cable to the network cable connector at the
camera's rear panel, then connect it to your network ( for example : your broadband cable/
DSL router)
The Antenna connector (for the wireless model IP CAM 2000): Screw the antenna on the
ANT connection and positionize it vertically.
Power connection: Connect the power supply to the 5V DC connection. Then plug in the
power adapter in the mains power outlet.
Reset button: If the reset button is pressed for more then 10 seconds, the camera will load
all default settings.
2 Software installation
Make sure that the IP CAM is connected by an Ethernet cable to your network.
Insert the CD rom into your computer.
The wireless model should also be connected by a network cable at this
point.