Perreaux ECD2 - Manual (Page 29)

28
Fuse Ratings
Mains input fuse
100 – 125V: ........................................................................ 2SB slow blow 0.5A
200 – 250V: ........................................................................ 2SB slow blow 0.5A
(user serviceable)
Weight
Net: ................................................................................................... 7.0kg (15.4lb)
(CD player only)
Gross:.............................................................................................. 10.0kg (22.0lb)
(CD player, accessories and packing material)
Specifications
Explained
Analog Rated Output ....................................................................................2.0V
RMS
This is the reference output level to which other specifications, such as signal to
noise ratio and total harmonic distortion, are referred.
Analog Output Impedance ..............................................................................100Ω
Output Impedance indicates the ability of the unit to drive the Line Level
Output. The low impedance of the ECD2 means that it will drive any
combination of cable configuration (length, capacitance, etc.) and component
impedance with ease whilst maintaining signal integrity.
Digital Output ................................................................................................... 0.5V
p-p
Indicates the peak-to-peak voltage of the signal from the digital output.
Digital Load Impedance ...................................................................................... 75Ω
Specifies the load impedance required for the coaxial digital interconnect.
Frequency Response ........................................................ 20Hz to 20kHz, ±0.5dB
Describes the frequency range where the amplitude or strength of the output
signal deviates from the source material by no more than 0.5dB
Total Harmonic Distortion
(THD+N)
.............................................. 0.004% @ 1kHz
Total Harmonic Distortion + Noise is the percentage of output signal which is
made up of frequencies added due to harmonics of the fundamental frequency
and noise.
Signal to Noise Ratio...................................................................................... >105dB
The ratio of desired signal to noise signals present in the output. This figure is
referenced to the rated output of the CD player, taking into full account all
potentially annoying hum components.
Dynamic Range .............................................................................................. >100dB
The difference between the loudest and quietest portions of a signal. Due to the
increased dynamic range offered by HDCD encoding, this specification must be
greater than the 96dB limit inherent in the standard 16-bit CD format.
Channel Separation.......................................................................... 110dB @ 1kHz
Refers to the immunity of a signal from one channel leaking to the other
channel. The higher the value, the better the isolation of the two channels.