Tiger Products Co., Ltd 6020009 - Manual (Page 54)

Twion Rtry Operation Section 3-6
OPERATION
When encountering a very severe condition which causes the tractor to stall,
disengage mower, start tractor, raise the mower from the cut. Shut tractor off and
inspect the mower, blades and disk for damage before engaging mower again.
If the blades jam or stop, disengage the clutch and raise the head slightly or back
the tractor up. Normally, this will clear the cutter head. If not, shut off the mower(s),
raise the cutter heads, turn off the tractor and set the parking brake. After all motion
stops completely, leave the tractor and clear the cutting heads manually.
After the first day of operation, all bolts should be checked and tightened securely.
This should be done periodically to ensure the bolts do not become loose and cause
damage to the tractor or mower, or injury to the operator.
REVERSE FAN OPERATION
Normal operation - Operating position is with fan switch ON (upper position)
Reversing fan to clear chaff
-Reverser fan switch is to be used as follows as
necessary for clearing chaff from cooling fins:
1. Normal operating position is with fan switch ON (upper position)
2. Turn fan switch OFF (center position), wait at least 3 seconds
3. Push switch DOWN to reverse,
4. Allow chaff to clear
5. Turn fan switch OFF (center position), wait at least 3 seconds
6. Turn fan switch to ON (upper position)