Tiger Products Co., Ltd 6020009 - Manual (Page 66)

Twin Rtry Maintenance Section 4-4
MAINTENANCE
WEEKLY OR EVERY 50 HOURS
ITEM SERVICE COMMENTS
In Tank Hyd. Fluid Change Change after first 50
Filter hours only, then every
(10 micron filter) 500 hours or yearly
In-Line High Pressure Change Change after first 50
Filter hours only, then every
(10 micron filter) 500 hours or yearly
MONTHLY OR EVERY 150 HOURS
Hydraulic Fluid Level Check Add as needed
Hyd. Tank Breather Clean / Check / Replace Clean or replace
Element as required
Rear Tire Type Max P.S.I.
480/80R38 29
18.4-34 26
18.4-38 26
YEARLY OR EVERY 500 HOURS
Spindle Grease Change
Motor to Spindle Spline Change
Hyd. Tank Fluid Change
In Tank Hyd. Fluid Filter Change
(10 micron filter)
In-Line HP Filter Change or Change when indicated
(10 micron filter) by restriction indicator.
Hyd. Tank Breather Change
TROUBLESHOOTING
SYMPTOMS CAUSE REMEDY
Vibration 1. Loose bolts 1. Check all bolts and tighten to
torque specs. in this section.
2. Cutter assembly 2a. Check for damaged blades, disc.
Unbalanced or cutter shaft. Replace if needed.
2b. Check for wire, rope, etc.
entangled in cutter assembly
Mower will not lift 1. Hyd. Fluid low 1. Check and refill Hyd. Fluid.
2. Leaks in line 2. Tighten or replace fittings and hoses
3. Faulty relief valve 3. Check pressure in line. Line
pressure in Control Valve should be
at least 2500 P.S.I.
4. Kinked / blocked 4. Clean or replace lines
5. Faulty cylinder 5. Inspect, repair or replace cylinder