Tannoy Z600 - Manual (Page 46)

White Paper Z600
46 September 2003
User interaction with SIM AT
DISPLAY TEXT
Text of up to 240 characters (120 UCS coded) is
supported. Text clearing times are 5-20 seconds
and a 60-second time-out limit for the user to clear
the text.‘Key’ responses:
• ‘Long Back’ – Proactive session terminated by
user.
• ‘Back’ – Backward move in proactive session.
Any other key clears display if the command is per-
formed successfully.
GET INKEY
Prompt for a one-character input. Pressing ‘Ok’
without entering a character gives warning mes-
sage “Minimum 1 character”. ‘Key’ responses:
• ‘C’ clears current character.
• ‘Long Back’ terminates the proactive session.
• ‘Back’ – Backward move in proactive session.
• ‘OK’ – Command performed successfully.
GET INPUT
Prompt for character input. The phone will refuse to
accept further input when maximum response
length is exceeded. MMI Maximum Response
lengths
• Digits Only – 160 characters
• SMS default alphabet characters – 160 charac-
ters
• Hidden Characters (digits only) – 20characters
‘Key’ responses:
• ‘C’ clears current character.
• ‘Long Back’ terminates the proactive session.
• ‘Back’ – Backward move in proactive session.
• ‘OK’ – Command performed successfully.
REFRESH
When a refresh command is executed by the
phone, it requests the user to wait while the phone
restarts. A notification will be made if it is
demanded that the SIM card initializes again.
SELECT ITEM
Scroll to highlight item for selection. ‘Key’
responses:
• Navigation key press down– Scroll down list.
• Navigation key press up– Scroll up list.
• Long ‘Back’ terminates proactive session.
• ‘Back’ – Backward move in proactive session.
• ‘OK’– Command performed successfully.
SEND SHORT MESSAGE
Default message “Sending message, please wait”
can be replaced for the Alpha Identifier text, or sup-
pressed completely if a null text is provided.
Default responses are “MESSAGE FAILED” or
“MESSAGE SENT”. ‘Key’ responses:
• Long ‘Back’ or ‘Back’ ends the proactive ses-
sion.
SET UP CALL
If the ME is on a call when the command ‘Set up
Call’, ‘putting all other calls on hold' is sent, the
user will see the text 'Setting up a call current call
will be held'. If ‘OK’ is pressed the current call will
be put on hold and the new call set up. If the ME is
on a call when the command ‘Set Up Call, discon-
necting all other calls’ is sent, the user will see the
text ‘Setting up a call current call will be discon-
nected’. If the ‘OK’ key is pressed the current call
will be disconnected and the new call set up.
SET UP MENU
Incorporates a SIM Application Toolkit Menu Item
into the ME’s main menu structure. From the
standby display the right or left arrow buttons can
be pressed to select the Menu Items.
If an Alpha Identifier is supplied in the Set Up Menu
command, this is used as the SIM AT entry in the
ME’s main menu. If no alpha identifier is supplied
and several items are found in the menu, a default
title is used. If the SIM AT Menu Item is selected by
pressing ‘Select’ all the items sent in the Set Up
Menu command will be available for selection, in
the same way as the Select Item command.