Replacing the bulbs – Thermador HDDW36FS User Manual
Page 9
Advertising
PAGE 9
REPLACING THE BULBS
4. Re-insert the bulb ring.
5. Restore the power by inserting the mains plug or
switching on the fuse.
Note: If the light does not function, check that the bulbs
have been inserted correctly.
ṇ
CAUTION. Avoid risk of electric shock.
1. Switch off the hood and pull out the mains plug or
switch off the electricity supply at the fuse box.
ṇ
CAUTION. Avoid risk of burns.
Halogen bulbs become very hot and remain hot for some
time after being switched off.
2. Remove the bulb ring with a screwdriver or similar tool.
3. Replace the halogen light bulb (conventional halogen
bulb, 12 Volt, max. 20 Watt, G4 bulbholder).
IMPORTANT: Plug-in bulbholder.
Take hold of the bulb with a clean cloth.
Finger prints can shorten bulb life.
Advertising