Thermador BOTTOM FREEZER 9000189698 - Manual (Page 21)

21
Resetting
factory settings
Recommended after a change of
owner.
q Simultaneously hold down the
SETUP and ALARM OFF
buttons for 3 seconds.
If the factory settings are reset:
- an appliance which is switched
off switches on,
- the Super function switches off,
- settings changed in Setup mode
are reset to factory settings.
Water filter
d
WARNING
d
To avoid serious illness or death,
do not use water that is
microbiological or chemical
unsafe or of unknow quality
without adequate disinfection or
other treatment before or after
use of filter.
Exchanging the filter
17.
d CAUTION d
- After installing a new water filter
always discard the ice
production of the first 24 hours
after swichting on the icemaker.
- If ice has not been used for a
prolonged time, discard all ice
cubes in the bin and discard the
ice production of the next
24 hours.
- If appliance or ice was not
actively used for several weeks
or months or ice cubes have an
unpleasant taste or odor,
change water filter.
- Air trapped in system may cause
water and cartridge to eject.
Use caution when removing.
- The filter should be changed at
least every 6 months.
If the following display is indicated:
The age of the filter is close to the
maximum life time. Order a new
"UltraClarity" water filter.
To purchase an "UltraClarity"
replacement water filter contact your
local dealer or call
1-800-578-6890 .
If the following display is indicated:
- The filter has to be changed
immediately.
1. Rotate the filter cap on the base
panel by 90-180
°
in an
antiĆclockwise direction.
2. Pull the used filter cartridge out
of the appliance.
3. Remove the cap from the used
filter.
Take a new filter cartridge out of the
packaging and remove the
protective cap.
4. Push the cap onto the new filter
cartridge.