Toro N-DR2000 - Manual (Page 7)

7
(1) Power switch
Press this switch to turn on the power. To turn off
the power, press this switch again.
After powering up : The system starts after
about 1 minute.
After powering down: The system shuts down
after about 30 seconds
(2) Message Indicator (Red)
Flashes or illuminates to indicate the action of
internal protection circuits.
Illuminated: Turn off the power supply to the
device for a short time. When the
power is turned on again, the light
should flash.
Flashing : Press the power switch on the front
panel to start the device.
(3) HDD access Indicator (Yellow)
LED flashes when the hard disk drive is being
accessed.
Note
When the system is started up, it performs a
check on the hard disk drive which may take
several minutes. During this time, the HDD
ACCESS LED will illuminate.
(4) Power Indicator (Green)
Flashes when the power is switched on.
(5) AC inlet
Connect the supplied power cord to this
receptacle.
(6) LAN 100BASE-TX/1000BASE-T
Connect the LAN cable.
5 6
[ Rear ]
HD D
VIDEO NETWORK
ME
SS A G E
RECORDER
POW
ER
N-DR2000 R20
1
WOR
TM
REC VID
4 2 3
[ Front ]
7. NOMENCLATURE AND FUNCTIONS
• MPEG-4 visual patent portfolio license
THIS PRODUCT IS LICENSED UNDER THE MPEG-4 VISUAL PATENT PORTFOLIO LICENSE FOR THE
PERSONAL AND NON-COMMERCIAL USE OF A CONSUMER FOR (1) ENCODING VIDEO IN
COMPLIANCE WITH THE MPEG-4 VISUAL STANDARD (“MPEG-4 VIDEO”)AND/OR (2) DECODING
MPEG-4 VIDEO THAT WAS ENCODED BY A CONSUMER ENGAGED IN A PERSONAL AND NON-
COMMERCIAL ACTIVITY AND/OR WAS OBTAINED FROM A VIDEO PROVIDER LICENSE BY MPEG LA
TO PROVIDE MPEG-4 VIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER
USE. ADDITIONAL INFORMATION INCLUDING THAT RELATING TO PROMOTIONAL, INTERNAL AND
COMMERCIAL USES AND LICENSING MAY BE OBTAINED FROM MPEG LA,LLC.
SEE HTTP://WWW.MPEGLA.COM.