Toastmaster 3342 - Manual (Page 5)

5
3. Stand the iron on its heel in an upright position on an iron-safe
surface and plug into a 120V ~ 60 Hz outlet.
4. Turn the temperature dial to maximum position.
5. Allow approximately 1 minute for the iron to reach the desired
temperature. The ready light will turn off.
6. Turn the variable steam dial clockwise for more steam and counter
clockwise for less steam. Turn the variable steam dial to position
for max steam.
7. When finished, turn temperature dial to MIN, turn variable steam dial
to O and unplug iron. Allow iron to cool before cleaning the exterior
of the iron or storing.
CAUTION: Avoid coming in contact with escaping steam.
BURST OF STEAM
For a penetrating burst of steam to iron faster and to smooth difficult
wrinkles, firmly depress the burst of steam button. Between the individual
bursts of steam, pause for at least 3 seconds to let the iron reheat for
maximum additional steam.
SPRAY
For a mist of water to moisten dry and difficult fabrics such as linen,
cotton or wool, or to handle stubborn wrinkles, press the spray button. The
spray function is also handy to moisten creases accidentally ironed into the
fabric. The spray function can be used on any setting and does not affect
the ironing temperature.
NOTE: You may have to pump the spray button several times the first time
you use the iron in order to start the spraying action.
USING THE VERTICAL STEAM FUNCTION
The vertical steam features allows you to eliminate wrinkles from drapes
without having to take them off the rod or to freshen the appearance of
clothing while on the hanger.
1. Unplug the iron from the outlet.
2. Fill the reservoir with water, see FILLING THE WATER RESERVOIR.
3. Position temperature control dial to MAX setting.
4. Stand the iron on its heel in an upright position on an iron-safe
surface and plug into 120V ~ 60 Hz outlet.
5. Allow approximately 1 minute for the iron to reach the desired
temperature. The ready light will turn off.
6. Hold the iron 7-15 inches away from the garment and press the burst
of steam button once.
7. Wait a few seconds before pressing the burst of steam button again.
The ready light will cycle on and then off during this process. Do not
press the burst of steam button more than three times successively
when ready light is ON. For best results, keep reservoir at least half
full.