Toastmaster 3342 - Manual (Page 6)

6
8. When finished, turn temperature dial to MIN, turn variable steam dial
to O and unplug iron. Allow iron to cool before cleaning the exterior
of the iron or storing.
CAUTION: Avoid coming in contact with escaping steam.
CLEANING STEAM VALVE
1. Turn the variable steam dial counter-clockwise to the descaling
position and pull out to remove from the iron.
2. Dip the steam valve into white vinegar to dissolve calcium and mineral
deposits.
3. Never use any sharp or rough objects to remove the deposits from the
Steam Valve.
4. Rinse the steam valve with tap water.
5. Replace the variable steam dial in the descaling position and gently
press down until in position.
6. Turn the variable steam dial to ‘O’ position.
DO NOT pour any chemicals into the water reservoir as they can damage
the iron.
FILLING THE WATER RESERVOIR
NOTE: FILL THE RESERVOIR WITH TAP WATER OR DISTILLED WATER. DO
NOT USE CHEMICALLY DESCALED WATER OR ANY OTHER LIQUIDS.
1. Unplug and allow the iron to cool before filling.
2. Turn the variable steam dial to no steam setting.
3. Hold the iron upright but slightly tipped.
4. Open the water fill cover by placing fingernail under one tab and lift
up.
5. Using the enclosed beaker or a measuring cup, slowly pour water into
the water fill. Do not fill past the maximum line on the water reservoir.
6. Close the water fill cover.
EMPTYING THE WATER RESERVOIR
NOTE: The water tank should be emptied after each use.
1. When finished, turn temperature control dial to MIN, turn the variable
steam dial to ‘O’ position and unplug the iron from the electrical outlet.
2. While the iron is still warm, hold the iron over a sink and allow the
iron to drain by tipping the point of the iron down.
3. Gently shake the iron to loosen any water drops that may be trapped.
The warmth of the iron should dry out any remaining water.
4. Press the burst of steam and spray buttons to release any water
remaining.
NOTE: If you empty the water reservoir after the iron has cooled, set the
iron in an upright position on its heel, plug it in and set the temperature dial
to maximum heat for 2 minutes. Then unplug the iron and let it cool before
storing it.