Conformity and compliance – Trilogy Touch Technology T3-HB15A1 User Manual
Page 15
Page 12
CONFORMITY AND COMPLIANCE
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential installation. This device generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
device does cause harmful interference to radio or television reception (this can be determined by turning, the device
off and on), you are encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RADIO FREQUENCY INTERFERENCE STATEMENT
Warning:
CANADIAN DOC NOTICE
For Class B Computing Devices
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in
the Radio Interference Regulation of the Canadian Department of Communications.
CE MARKING DECLARATION OF CONFORMITY
This LCD Monitor complies with the requirements of related European standards, which include:
•
Emission: EN 55022, EN 61000-3-2, EN-61000-3-3
•
Immunity: EN 50082-1
•
Safety: EN 60950 [Low-Voltage Directive (73/23/EEC)
ENERGY STAR
This product meets the Energy Star guidelines for energy
efficiency.
Caution
To comply with the limits for an FCC Class B computing device, you should use the shielded
signal cord and shielded power cord supplied with this unit. The Federal Communication
Commission warns that changes or modifications of the unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
This is a Class B product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.