Targus Screen Scroller Mouse - Manual (Page 4)

4
Connecting the Mouse to the PS/2 Port
NOTE: If you are running the Macintosh operating system, the
you must connect the mouse to your computer’s USB port.
See “Connecting the Mouse to the USB Port.”
To connect the mouse to an available PS/2 port:
1 Turn off your computer.
2 Disconnect the existing mouse, if one is attached.
3 Plug the standard USB end of the cable into the USB port
on the PS/2 adapter
Screen scroller mouse and PS/2 adapter
4 Plug the PS/2 adapter into an available PS/2 port on your
computer.
You are now ready to install the device drivers for your
operating system.
NOTE: Only the standard scrolling features are available when
the mouse is connected to the PS/2 port.
Installing the Device Drivers
If the operating system you are running supports Plug and Play
operation, it installs the default device drivers automatically.
Otherwise, use the following procedures to install the default
device drivers for your operating system.