Trek 11i EN - Manual (Page 8)

6 Installation
Check that the computer base cannot
be rotated around the handlebar,
and that the computer cannot slide
backwards on the computer base
(Figure 5).
To install the computer on the stem
1. Insert the rubber friction pad into
the computer base, aligned along the
computer base.
2. Insert two nylon ties through the
computer base (Figure 6).
3. Place the base on the stem and tighten the
nylon tie.
4. Slide the computer into the computer
base until the front of the computer and
computer base line up.
5. Check that the computer base cannot be
rotated around the stem and the computer
cannot slide backwards on the computer
base.
6. Tighten the nylon ties and trim the excess
length.
Figure 6- nylon tie threaded
through computer base
Figure 5- Make sure the com-
puter cannot be bounced off.