Thermador T24IR - Manual (Page 7)

7
Installation
d WARNING d
Do not install the appliance:
- outdoors,
- in an environment with dripping
water,
- in rooms which are at risk of
frost.
The appliance is very heavy ć for
empty weight see the following
table:
Refrigerator 24" 310 lbs / 140 kg
Refrigerator 30" 350 lbs / 158 kg
Installation room
The appliance should be installed in
a dry, well ventilated room.
The ambient temperature should not
drop below 55 ° F (13 ° C) or rise
above 110 ° F (43 ° C), otherwise
malfunctions may occur.
The installation location should not
be exposed to direct sunlight and
not placed near a heat source, such
as an oven, radiator, etc.
If installation next to a heat source is
unavoidable, use a suitable
insulating plate or observe the
following minimum distances from
the heat source:
- 1.2" (3 cm) from an electric
cooker,
- 12" (30 cm) from an oil or
solidĆfuel cooker.
Installation cavity
It is important to observe the
specified dimensions of the
installation cavity for a troubleĆfree
installation of the appliance and for
the subsequent general view of the
furniture front.
In particular ensure that the cavity is
square. Squareness can be checked
by suitable means, e.g. spirit level,
diagonal measurements, etc.
Furniture/fixtures
The new appliance will be mounted
securely to adjacent and overhead
furniture/fixtures.
For this reason it is essential that all
attachable furniture/fixtures are
connected securely to the base or
the wall by suitable means.
Base
To ensure that the appliance is
installed securely and functions
properly, the base must be flat and
level.
The base must be made of a hard,
rigid material.
The installation area must be the
same height as the rest of the room.
On account of the heavy weight of
a fully loaded appliance,
a loadĆbearing base is required.
For fullyĆloaded weight see the
following table:
- Refrigerator 24" 890 lbs / 400 kg
- Refrigerator 30" 1110 lbs / 500
kg
If in doubt, contact an architect or
a building expert.
Installing and
connecting the
appliance
d CAUTION d
Have the appliance installed by an
electrician according to the
enclosed installation instructions.
After installing the appliance, wait at
least before switching on the
appliance. During transit the oil in
the refrigeration system may have
moved.
Before switching on the appliance
for the first time, clean the inside of
the appliance.
Connection
to the power
supply
d WARNING d
Avoid Electrical Shock
Hazard
- Plug into a grounded 3 prong
outlet.
- Do not remove ground prong.
- Do not use an adapter.
- Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
Improper connection of the
equipment grounding conductor
may result in electric shock. Have
the appliance checked by a
qualified electrician or service
technician if you are in doubt as
to whether the appliance has
been properly grounded.
The appliance comes with an UL
listed, 3Ćwire power supply cord.
The appliance requires a 3Ćwire
receptacle.
The receptacle must be installed by
a licensed electrician only.