Perreaux AVP1 - Manual (Page 3)

3
washbowl, kitchen sink, laundry tub, in a
wet basement, near a swimming pool,
etc.
5. Rack / Wall / Ceiling Mounting
The AVP1 should be rack mounted only
in a heavy-duty rack or stand that is
recommended for audio equipment use.
Mounting to a wall or ceiling should be
via a heavy-duty bracket or shelf
designed for audio equipment use.
6. Heat
The AVP1 should be situated away from
heat sources such as radiators, stoves,
or other appliances that produce
excessive amounts of heat.
7. Power Sources
The AVP1 should be connected to
mains power supply only of the type
described in the operating instructions,
or as marked on the rear of the AVP1
8. Power Cord Protection
The mains power supply cord should be
routed so that it is not likely to be walked
on or pinched by items placed on or
against it. Pay particular attention to the
cord at power points, convenience
receptacles, and the point where it exits
from the AVP1.
9. Cleaning
When cleaning any Perreaux product
use lukewarm water with a few drops of
mild detergent.
DO NOT USE SOLVENTS.
10. Non-use Periods
The mains power cord of the AVP1
should be unplugged from the
mains/line outlet when the unit is to be
left unused for long periods of time.
11. Object and Liquid Entry
Care should be taken so that objects
and/or liquids do not accidentally fall
inside the AVP1.
12. Damage Requiring Service
Qualified service personnel should
service the AVP1 if any of the following
occur:
a. The mains power-supply cord,
and/or plug have been damaged
b. Objects have fallen, or liquid has
been spilt into the AVP1
c. The AVP1 has been exposed to
rain and/or excessive moisture
d. The AVP1 does not appear to
operate normally, or exhibits a
marked change in performance
e. The AVP1 has been dropped, or
the chassis damaged.
13. Servicing
The user should not attempt to service
the AVP1 beyond those means
described in the owners’ manual. All
other servicing should be referred to
qualified service personnel.
14. Grounding or Polarisation
Precautions should be taken so that the
grounding or polarisation of the AVP1
are correct, and are maintained
throughout the entire system.
IMPORTANT INFORMATION
Always make sure the attenuator / volume
control of your AVP1 or source unit is set to
–80dB and the mains/line supply
disconnected from your AVP1 prior to
performing any switching functions or
connection alterations of any type to your
AVP1, or to any other part of your entire
system. This caution also applies to the
normal use of your Laser Disc player, Tuner,
Cassette Deck, etc.
PRODUCT SUPPLIED WITHOUT
MAINS PLUG
If your unit comes with a 3-core cable but
without a plug, make certain LIVE and
NEUTRAL leads are connected correctly to
your plug terminals.
IMPORTANT: The wires of the
mains/line lead in this unit are coloured
in accordance with the following code:
BROWN
LIVE
BLUE NEUTRAL
GREEN/YELLOW
EARTH/GROUND
As the wire colours in the mains lead of this
unit may not correspond exactly with those
coloured markings on the terminals of your
plug proceed as follows:
-
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter N, or colour
coded BLUE or BLACK.
- The wire which is coloured BROWN
must be connected to the terminal which
is marked with the letter P or L, or colour
coded BROWN or RED.
- The wire which is coloured
GREEN/YELLOW must be connected to
the terminal which is marked with the
letter E, or colour coded
GREEN/YELLOW or GREEN.
NOTE: Any modifications to the
mains/line voltage setting within your
AVP1 may only be carried out by a