Turbosound ASPECT TA-500 SYSTEM TA-500HDP - Manual (Page 32)

user manual
TA-500
TA-500 user manual
Page 32
The lower link must fit into the flygear in a specific way to ensure the reinforcing part bears
on the flygear appropriately:
the link must be inserted correctly. Make sure that when using the 21° position
the link is fitted parallel to the cabinet side.
Figure 7: Lower link positioning looking from bottom of cabinet
Setting the angles between rows
The setting of the angles between the rows is easily achieved by selecting the desired hole in
the index link relating the angle:
Figure 8: Index link angle setting
Attaching the biscuit
Once the inter-cabinet chains have been connected both sides, the captive biscuit must be
engaged. To do this, the biscuit is pushed out of its holder in the upper cabinet into the upper
kelping bracket of the lower cabinet: