Topcom Butler 4812 USB VOIP User Manual
Page 22
22
Topcom Butler 4812 USB VoIP
Topcom Butler 4812 USB VoIP
4.26.2 Manual selection
If you set the handset to ‘manual selection’, the handset will only choose the base unit you
have set.
•
Press the Programming key .
•
Press the Up or Down key
repeatedly until ‘SETTING’ appears on the display.
•
Press the Programming key .
•
Press the Up or Down key
repeatedly until ‘BASE SEL’ appears on the display.
•
Press the Programming key .
•
Press the Up or Down key
repeatedly until ‘MANUAL’ appears on the display.
•
Press the Programming key .
•
‘BASE -‘ appears on the display.
•
Enter the number of the base unit you want to select (1-4). Use the number keypad.
•
Press the Programming key .
•
‘SEARCHING’ and the symbol appear on the display.
•
A signal sounds once the selected base unit has been found.
4.27 Barring outgoing calls
You can program the handsets to bar calls to certain telephone numbers so that for instance
‘00’ international numbers cannot be called. Up to 5 numbers (of max. 5 digits) can be barred.
To do this, do the following:
•
Press the Programming key .
•
Press the Up or Down key
repeatedly until ‘SETTING’ appears on the display.
•
Press the Programming key .
•
Press the Up or Down key
repeatedly until ‘BARRING’ appears on the display.
•
Press the Programming key .
•
‘PIN’ appears on the display.
•
Enter your PIN code
•
Press the Programming key .
•
‘BAR NUM ’ appears on the display. You are in memory “1. _ _ _ _ _”.
•
Press the Up or Down key
to select one of the 5 memories.
•
Enter the number (max. 5 digits) to be barred, e.g. 01486.
•
Press the Programming key .
•
‘HS _ _ _ _ _’ (= number on the handset (1-5)) ‘01486’ (= the barred numbers) appear
on the display.
•
Enter the numbers of the handsets from which the barred numbers cannot be called.
•
e.g. Press the number key 2, 3 and 5. On the display, this will appear: HS _2 3_5 01486
These handsets can no longer dial numbers beginning with ‘01486’.
•
Press the Programming key to confirm your selection. Repeat the same procedure
described above if you would like to bar other numbers (max. 5)!
•
Before you can select a base unit, the base unit must be subscribed to
the handset first.
•
If ‘NOT SUB’ appears on the display, this means the selected base unit
does not exist or the handset has not been subscribed.