Telular SX6P GSM - Manual (Page 8)

Phonecell ® SX6P GSM 2 User Manual
Battery Operation
The SX6P will recharge its battery pack when connected to AC power. If AC power is interrupted,
the SX6P will continue to operate, using power from the battery. (Standby and talk-times will vary
based upon phone usage during power interruption.)
Location and Setup
The SX6P comes with a standard spike antenna (TNC).
NOTE: The supplied antenna will support either 850/1900 MHz or 900/1800 MHz frequincies,
as specified by your wirless service network provider.
1. Attach and finger-tighten the antenna - see Figure 4. Do not over-tighten the antenna.
2. Select a location that is above ground and as close to windows (or exterior walls) as possible
to get the best signal - see Figure 5.
Connect the Handset
Before you can use the SX6P, you must connect the handset cable.
1. Connect the handset cable to the phone jack - see Figure 6.
2. Connect the handset cable to the handset - see Figure 6.
Phone jack
Handset cable
Figure 4 - Attach the antenna. Figure 5 - SX6P location.
Handset
Figure 6– SX6P handset connection.