Test-Um NT750 - Manual (Page 2)

LanScaper
TM
RJ45 Jack - Connect to
cable or jack to be tested.
Link Indicator
- On when
network link is established.
Curser Keys - Used to scroll
through options, set addresses
and adjust values.
Sel Key - Select key is used to
enter displayed operating mode,
start a new test, change the
value of an option, enter
sub-menus or move
to the next screen.
(Depending on context)
Mode Key - Press CABLE for
cable modes, press NTWRK
for network modes or press the
center (both at once) for SETUP
mode.
Power Key - Press PWR to turn
on the LanScaper
in the mode at
power off. Further presses of PWR
toggle the back light on and off.
Hold down to turn off.
Battery Cap - Press down
with heel of hand to open.
Back-lit LCD - 2 lines
by 16 characters w/ icons.