Tekkeon MP3300 - Manual (Page 5)

3 USER GUIDE
Getting to Know myPower ALL
Charging myPower ALL
myPower ALL will charge in four hours when completely empty. The green CHARGE indicator will turn
on after the battery is 80% charged. Therefore, you should view the actual battery capacity before
disconnecting the power adapter to stop charging. (Before using myPower ALL for the first time, you
must charge the device for four hours.)
1. Plug the power adapter into the DC IN jack on the end of myPower ALL.
2. Remove the output cord from the DC OUT jack, if connected.
3. Plug the power adapter into a wall outlet. The red CHARGE indicator will turn on to indicate the
battery is charging and is less than 80% charged.
4. When the green CHARGE indicator turns on, set the voltage lock to LOCK, and press the voltage
selector to view the battery capacity. If the capacity does not indicate FULL, continue to charge the
battery until the battery capacity indicates FULL.
5. When the battery capacity indicates FULL, unplug the power adapter.
NOTE: myPower ALL will automatically shut down the power input when fully charged, so you can
charge it overnight.
Voltage Indicators/
Capacity Indicators
Voltage Lock
DC OUT
For connection to device DC IN
For connection to power adapter
Voltage Selector
Charging Indicator