Tekkeon MP3300 - Manual (Page 9)

7 USER GUIDE
the device. If it is less than 64W, set the voltage on MP3300 to 12V and test to see if it will power your
notebook at this setting. If not, increase the voltage to 14V and retest.
Most portable DVD players require 9 or 12 volts. Set the voltage to 7.5V and test to see if myPower ALL
will power your device at this setting. If not, increase the voltage by one level and retest.
Connect the Portable Device
1. Connect the adapter plug into the power jack on the portable device.
2. Turn on the portable device and use it as you would normally. While connected, myPower ALL will
power and charge your device. (As mentioned earlier, myPower ALL will not charge a device if the
voltage setting is lower than that required.)
or
Leave the portable device turned off and myPower ALL will charge the device battery.
3. When finished, unplug the power output cord from myPower ALL and your device.
NOTE: If your portable device displays a low voltage/low capacity or double-beep warning while
myPower ALL is connected, adjust the voltage setting to one level higher.
TIP: For most portable devices, myPower ALL can be used to power the device even when the device
battery is not installed.