Install the cpsmp-120 – Transition Networks CPSMP-120 User Manual
Page 2
CPSMP-120
2
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing or servicing the power supply module. Failure to
observe this caution could result in damage to, and subsequent failure of, the
power supply module.
CPSMP-120 in the 13-Slot Chassis
The CPSMP-120 power supply module may replace an existing CPSMP-120
module or be installed in the second installation slot (see drawing below) of the
CPSMC1300-100 13-slot chassis to become the optional, redundant power
supply.
NOTE: The CPSMP-120 power supply module may also be installed as the
redundant power supply in either DC-powered 13-slot chassis:
•
CPSMC1310-100 (48-VDC chassis)
•
CPSMC1320-100 (24-VDC chassis)
For more information, see the user’s guide for the CPSMC13xx-100 13-slot
chassis on-line at: www.transition.com.
AC Power
Supply
I
0
Second
Installation Slot
3
[email protected] -- Click the “Transition Now” link for a live Web chat.
WARNING: Do not connect the power supply module to the external power
source before installing it into the chassis. Failure to observe this caution could
result in equipment damage and/or personal injury or death.
Install the CPSMP-120
CAUTION: Ensure that the power supply module has been disconnected
from the external power source and the module’s On/Off switch has been
set to “0”. Failure to observe this caution could result in damage to, and
subsequent failure of, the power supply module.
NOTE: The CPSMP-120 power supply module may be “hot swapped” (i.e.,
installed in the chassis while the chassis is in operation) provided the module
to be installed has been disconnected from its external power source and the
module’s On/Off switch has been set to “0”.
To install the CPSMP-120 power supply module into the CPSMC13xx-100
chassis:
1.
Loosen the screw that secures the protective plate to the chassis and pull
the plate away from the chassis.
2.
Ensure the On/Off switch on the power supply module is set to “0”.
3.
Carefully slide the power supply module into the installation slot,
aligning the module with the installation guides.
4.
Ensure that the power supply module is firmly seated inside the chassis.
5.
Rotate the attached panel fastener screw clockwise to secure the power
supply module to the chassis.
I
0
I
0
I
0
Panel
Fastener
Screw