Connect to external power, Replace the cpsmp-120 – Transition Networks CPSMP-120 User Manual
Page 3
CPSMP-120
4
24-hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Connect to External Power
CAUTION: Ensure that the On/Off switch on the power supply module is set
to “0” when connecting to the external power source. Failure to observe
this caution could result in damage to, and subsequent failure of, the power
supply module.
To power the CPSMP-120 power supply module:
1.
Set the On/Off switch on the power supply module to “0”.
2.
Connect the female end of the AC power cord to the male end of the
external power connector.
3.
Connect the male end of the AC power cord into the correct voltage AC
rack or wall socket.
4.
Set the power supply module power switch to “I”.
5.
Verify that the CPSMP-120 power supply module is powered by
observing the illuminated power LED.
Panel Fastener Screw
External Power Connector
AC Power Cord
I
0
On/Off
Switch
Power LED
5
[email protected] -- Click the “Transition Now” link for a live Web chat.
WARNING: Do not connect the power supply module to the external power
source before installing it into the chassis. Failure to observe this caution could
result in equipment damage and/or personal injury or death.
Replace the CPSMP-120
CAUTION: Ensure that the power supply module has been disconnected
from the external power source and the module’s On/Off switch has been
set to “0”. Failure to observe this caution could result in damage to, and
subsequent failure of, the power supply module.
NOTE: The CPSMP-120 power supply module may be “hot swapped” (i.e.,
replaced while the chassis is in operation) provided the module to be
replaced has been disconnected from its external power source and the
module’s On/Off switch has been set to “0”.
To replace the CPSMP-120 power supply module:
1.
Ensure the On/Off switch on the power supply module is set to “0”.
2.
Disconnect the the male end of the AC power cord from the AC rack or
wall socket.
3.
Disconnect the female end of the AC power cord from the external power
connector.
4.
Rotate the attached panel fastener screw counter-clockwise.
5.
Carefully slide the power supply module to be replaced out of the
chassis.
I
0
I
0
Panel
Fastener
Screw