Technicolor - Thomson DPL590 - Manual (Page 8)

Getting Started
EN
5
Digital Connections
Read instructions carefully when connecting
components to the receiver.
Digital In Jacks can accept Dolby Digital (AC-3) or PCM
signals when compatible components are
connected.
TV Connections
TVs with RF input may need a RF modulator (not
included) for inputting audio signals.
Connecting the Antennas
The AM and FM antennas connect to the AM and FM
terminals on the system’s back panel.
They must be hooked up in order to receive clear
reception.
AM Loop Antenna and FM Indoor Antenna
1. Uncoil the Antenna wire and locate the base end of
the AM antenna.
2. Press down on the Antenna tab to open the terminal.
3. Inert the antenna wires into the terminal and release
the tabs to secure the wires in place.
FM 75‰
3‰ FR FL SR SL CEN SUB 6‰
SPEAKERS
DIGITAL AUDIO
COAXIAL OPTICAL
GND AM LOOP
SAT / DVD / CD Player / TV
COAXIAL DIGITAL IN (AUDIO)
Connect to coaxial digital output of
DVD, CD, SAT or other compatible
devices.
OPTICAL DIGITAL IN (AUDIO)
Optical Fiber Cable
Connect to optical digital output of
DVD, CD, SAT or other compatible
devices.
DVD / CD / SAT
DIGITAL AUDIO
COAXIAL OPTICAL
AUDIO INPUT
DVD SAT TV VCR CD TAPE
L
R
IN SUBWOOFER AUDIO OUT
HINT
• For FM reception, extend antenna to its full
length.
• For AM reception, rotate the antenna
horizontally to get better reception.
RF modulator
TV
RF cable
Audio cable
The diagram shown above may varies from your actual RF
modulator, please refer to your RF modulator manual.
Audio in
Audio out
RF in RF out
DPL590 EN 12/16/04 3:58 PM Page 9