Telular SX6P - Manual (Page 34)

SENDING/RECEIVING 1X DATA (SX6P-300C series only)
Check with your service provider to see if your account supports 1X data transfer.
Set the SX6’s Baud Rate for 1X Data
1. Start by pressing MENU.
2. Select 6: Data Settings.
3. Select 1: Baud Rate.
4. Select 115200 and Press STO to save. This is the communication speed between the
computer and SX6P; data transfer rates will be much slower.
Set Your Computer’s Port and Modem Speeds for 1X Data
To send or receive circuit switched data, you need to set the port and modem speeds your
computer uses for the SX6P to 115200 bps. See Windows XP/2000 Setup (pages 24 & 26) for
details. This is the communication speed between the computer and SX6P; data transfer rates
will be much slower.
To Send or Receive 1X Data
Follow your service provider’s directions for sending and receiving 1X data. Whenever your
software asks you what modem to use, select the Standard 19200 Modem.
For Windows XP and Windows 2000, you can start by opening Control Panel > Network and
Dial Up Connections, then double-clicking on “Make New Connection” to start the Network
Connection Wizard.
Note: Taking the SX6P off hook during a data session will end the session.
Phonecell ® SX6P CDMA 28 Technical Manual