Toro GREENSMASTER 3100 - Manual (Page 96)

14. Install 1-1/4" diameter dust seal in seal gland bush-
ing, flat or smooth side of dust seal must face down
towards bushing, see Fig. 60.
15. Install the quad-ring seal in seal gland bushing.
Smooth seal in place with your finger. Do not use any
seal that falls freely into pocket of bushing, see Fig. 60.
16. Install seal gland bushing over the spool end with a
twisting motion. Tap the bushing in place with a rubber
hammer. Make sure the bushing is flush against the
bearing race.
17. Install retaining ring (see Fig. 59 - 60) in housing.
After installing ring, tap on ring end or pry with screw-
driver around entire circumference of ring to properly
seat ring in groove.
Figure 59
Figure 60
Repairs Page 4 - 68 Greensmaster
®
3100