Tricity Bendix SG 205WL - Manual (Page 21)

21
Levelling
Fix the support with two legs by means of
washer and nuts, delivered with the cooker, see
the figure.
GAS CONNECTIONS
Your cooker is delivered adjusted for the kind of
gas stated on the rating plate.
If the appliance is converted to natural gas and
the pressure for natural gas is 20mbar, the
following methods of connection to the gas
supply must be used:
Right Hand Connection (from front)
Ensure that the rubber hose is not in contact
with any part of the shaded area shown in the
diagram and that the loop of the hose when
connected is not in contact with the floor when
the appliance is in position.
Left Hand Connection (from front)
Ensure that the rubber hose is not in contact
with any part of the shaded area shown in the
diagram and the hose is retained in the clamp
provided, it will be necessary to fit the maximum
length hose when using this method.
Rigid Connection
Where it is not possible to make the connection
using a rubber hose, a rigid pipe work
connection must be used.
Recommendations when using an appliance
flexible connector are as follows:
- For NATURAL the gas installation pipes to the
termination point shall comply with:
Specification for installation of low-pressure
gas pipe work of up to 20mm (R1) in
domestic premises (2nd family gas) – BS
6891;
BACK OF THE COOKER
BACK OF THE COOKER
Connection
of flexible
hose
A
Clamp